When you get a video projector, you may not consider the cleaning that needs to be done on a regular basis.
Unless, of course, you like to get a layer of dust, or worse, dirty the quality of your photos.
These steps can help you if you want to make your system clean.
We will break it down together.
This means the correct instructions for the projector housing, lens and screen.
When you finish, you will finish cleaning the whole system.
When it comes to the projector housing, the biggest problem you will have is dust.
Like many other fixed electronics, the projector box collects dust like crazy.
If you need to remove dust without adding any dust, follow these steps: 1.
Use electronic wipes, cotton swabs and projector boxes for installation in comfortable, well-lit areas. 2.
Wipe out from the center of the box to the edge of the box.
When you wipe near the vent, do not wipe the vent with a second-hand wipeavoid them.
In any case, wipe the seam with your nails. 3.
Clean the vent with a cotton swab.
Use the roll-over shovel movement to capture the dust without allowing it to fall into the slot. 4.
Now, if you fail, you need to wipe the tip of the cotton swab with a wet towel and run between the vents on a flat surface.
As before, work from center to edge.
Now your projector case is as clean as the day you bought it.
The cleanliness of the projector lens will most directly affect the quality of the image.
To clean the lens, simply follow these steps.
The best way to do this is to use air: 1.
Go to the store and buy a light bulb.
You can go to the camera store or to the baby passage at the local pharmacy. 2.
Close the bulb very close to the lens without touching the lens. 3.
Give a few air that works in clockwise mode.
Note: do not do this using compressed electronic air.
These jars release a small amount of liquid and the air can be seen on your lens.
Projector screen if you spend extra money on a matching screen instead of just projecting onto the wall, then you will want to protect the investment.
Keeping the screen clean is simple.
Just follow these simple steps.
You may want to use products like Windex on your screen. Don’t do it.
They all leave residues that will reduce the quality of your screen.
If you only have dust on your screen, wipe it with a dry rag.
Work from center to edge.
Ideally, a rag should be a lint-free cloth, just like a cloth for electronic products or glasses.
If you already have a position on the screen, use clear water at room temperature.
Wet the corner of the fabric with it and rub the spots gently.
Then gently buff dry with a dry corner.
Now your system will be clean and your picture will be clear.
Enjoy your viewing experience.