I created this fix guide because I was always confused when my cable charger was broken and I couldn't find any search engine instructions on fixing this thing.
The cable for the Samsung Galaxy Tab is similar to my actual gadget Galaxy note 10. 1 [GT-N8000]. OK . . . . lets start it1.
The cable itself is broken. cutter3. tweezers4.
Soldering tin setlast touches other 【i use]1. tape2.
Ethyl propylene chloride [liquid glue]3.
Please observe carefully if there is an unconnected cable. . .
Find it and weld it to this ceremony :)in my stuff . . .
The etiquette place is that there is no wire to the front of the tin dot. . . only tin spot . . .
Please also check my sketch for information. Open the wire using the hot tip welding tool only. . . [
1st I used razors and unfortunately cut them off. . lol ]
Check this 1st before you assemble all the open parts together. I have two chargers and both have the same problem. . .
Is this some of Samsung's failed charger products?
Before plugging the cable charger into the device. . .
Look at your battery. . . remember it . . .
Plug in the charger and wait to see for minutes.
If everything is OK, the battery will increase.
Make sure it's really fixed! ! !
If the battery does not increase after more than three minutes. . .
Re-check your work and find something that is not well connected. . . .
And fix it to make sure everything is back to normal. . .
Let this repaired cable charge your device. good? ok . . .
Let's do the last step until everything is done and running properly. . .
After all parts are assembled, perform this step to make the cables we have repaired strong enough to meet our daily use. . . .
If once you need to repair again, cover all of these material surfaces with your adhesive tape to avoid glue damage to important parts. basicly . . .
Depending on what material you want to cover these things [e.
Epoxy resin, resin, paint, putty, product packaging, etc. ]
I chose the acrylic acetate and combined it with the cut fabric. . . .
Before we cover the area, stick the lill bit glue on the fabric first. . . .
Until it is covered with fabric. . . .
Drop the liquid glue on it. . . .
Only wet the fabric and stick it on chargerdo layer by layer until you feel enough. . . .
Make it dry and hard, it might be useful for you :)