how to troubleshoot a husqvarna viking designer 1 - touch the screen

Husqvarna Viking designer 1 is a digital sewing machine.
It includes a touch screen display and a floppy drive to upload the embroidery design to the machine.
While the build feature of designer 1 is strong, you may still encounter errors with device components.
If you do run into problems with designer 1, there are a few things you can do to solve them.
If the virtual button of the device fails, recalibrate the touch screen display of designer 1.
Power supply for designer 1.
At the same time, press the "reverse feed" and "sensor pivot foot" buttons to enter the service menu of the device.
Press the "Cal" button on the display.
Tap the "" mark on the display to re-calibrate the touch screen display.
Remove the floppy disk and re-insert the floppy disk if you receive a floppy disk read error on the monitor of designer 1.
If you continue to encounter a read error, try inserting another floppy disk.
If the second floppy disk is also unreadable, restart designer 1.
If the second floppy disk works, the first floppy disk may be damaged.
If the disk is damaged, you can insert it into your computer's floppy drive and try to recycle any readable data from the disk, or contact Husqvarna to replace it.
If your embroidery stitching jumps or jumps when using a two-pin configuration, re-adjust the stitch or sew with a single stitch.
Loosen the screws behind the needle rod to take out one of the needles or adjust the level of the needle rod.
Alternatively, you can click on the settings option on the designer 1 display and select the single PIN option to set the machine to use only one of the pins.
If your machine is not stitched, clear any pop-up messages displayed by designer 1.
Click OK or close on any pop-up ".
Set the reminder of the machine to manual, limiting the number of pop-up messages on the display.
Touch the settings option on the designer 1 display, click more, click help, and then click manual ".
"If you receive a spool warning message on the sewing machine display, please wrap the spool of your designer 1.
The icon of the line axis where the line is broken indicates that the line of the line axis is broken.
Restore the backlight to the display of designer 1 by turning off the "screen saver" option of the machine.
Click Settings on the machine's display, click more, and then click on the close option next to the screen saver option.