replacement wacom pen nibs in about 5 minutes - wacom pen tablet

You can replace the Wacom Bamboo pen nibs in about five minutes.
People have been using weed trimming lines, but I am.
065 inch in diameter, too big for the pen that came with my Wacom Bamboo model CTH-460.
There is also the problem of straightening the production line.
It is correct to buy a straight plastic stick.
A diameter of 060 will save you a lot of time. You will need:. 060 (1/16)
The inch plastic stick offered by TAP Plastics costs $.
075 is 6 feet.
You can buy it online for $7. 50 for ten.
Another option is to look.
060 fiber optic line. -A file. -
Electric drill. -Sandpaper, 200-1500 grade. -
Optional: the neon sharp Eli page protectorPlastic Rod should be as close as possible.
The diameter is as 060 inch as possible.
Remove the worn tip (
You may need tweezers or small needle pliers).
Insert the plastic stick into the Wacom pen.
Cut plastic 1 inch or more from the pen.
Put the drill bit into the drill bit, tighten it at a 90 degree angle and keep the file while running the drill bit at medium speed to flatten the drill bit.
You have to see what speed is best for you.
This will be the end of the pen.
The inverted Rod begins to be shaped. (see image)
This should take only a few seconds to draw a rough shape.
Continue to plastic with sandpaper and finish with ultra-fine 1200-
1500 wet/dry sandpaper until smooth and polished.
Your new tip is ready. Smooth polishing.
Now that you have a new Wacom pen tip, you don't want to throw it away in order to make it disappear forever under the carpet or furniture.
Once a few permanent fluorescent markers are given, your pen tip gives a bright light when the UV is shining and is easy to find.
Photos taken in a dark room with only UV light on the tip of the pen.
To use the pen more smoothly, you can put the tablet in an Avery plastic board protector.
Any thin-page protector or similar plastic should work.
Just cut into a certain size and pull the slack part on the back and the tape tightly.